STAT
Displays the status of database settings.
In the DISPLAY program, STAT will show the current status of the program settings.
In the ANSYS program, STAT is a command generated by the GUI and will appear in the log file (Jobname.LOG) if status is requested for some items under . Generally, STAT will be preceded by one of the commands listed below, which specifies the particular topic that status was requested for.
If entered directly into the program, the STAT command should be immediately preceded by the desired topic command listed below. In processors other than those listed below (e.g., AUX12), no topic command should proceed STAT.
This command is valid in any processor.
PREP7 topic commands (and their corresponding topics) are:
| Topic Command | Topic |
|---|---|
| ETYPE | Element types |
| RCON | Real constants |
| MATER | Material properties |
| TBLE | Data table properties |
| PRIM | Solid model primitives |
| KEYPTS | Keypoints |
| LINE | Lines |
| AREAS | Areas |
| VOLUMES | Volumes |
| GEOMETRY | Solid model information |
| MESHING | Meshing |
| BOOL | Booleans |
| NODES | Nodes |
| ELEM | Elements |
| SELM | Superelements |
| DIGIT | Node digitizing |
| COUPLE | Node coupling |
| CEQN | Constraint equations |
SOLUTION topic commands (and their corresponding topics) are:
| Topic Command | Topic |
|---|---|
| ATYPE | Analysis types |
| MASTER | Master DOF |
| GAP | Reduced transient gap conditions |
| DEACT | Element birth and death (deactivation) |
| LSOPER | Load step operations |
| FECONS | Constraints on nodes |
| FEFOR | Forces on nodes |
| FESURF | Surface loads on elements |
| FEBODY | Body loads on elements |
| SMCONS | Constraints on the solid model |
| SMFOR | Forces on the solid model |
| SMSURF | Surface loads on the solid model |
| SMBODY | Body loads on the solid model |
| INRTIA | Inertial loads |
| GENOPT | General options |
| DYNOPT | Dynamic analysis options |
| NLOPT | Nonlinear analysis options |
| OUTOPT | Output options |
| BIOOPT | Biot-Savart options |
| SPTOPT | Spectrum analysis options |
| SOLUOPT | Solution options |
POST1 topic commands (and their corresponding topics) are:
| Topic Command | Topic |
|---|---|
| DEFINE | Data definition settings |
| SORT | Sort settings |
| Print settings | |
| DISPLAY | Display settings |
| CALC | Calculation settings |
| PATH | Path data settings |
| LCCALC | Load case settings |
| DATADEF | Directly defined data status |
| POINT | Point flow tracing settings |
| SPEC | Miscellaneous specifications |
POST26 topic commands (and their corresponding topics) are: