Shows magnitude of body force loads on displays.
Label identifying the item:
Applied heat generation rates.
Applied current density magnitude.
X-component of current density.
Y-component of current density.
Z-component of current density.
Phase angle of applied load.
Applied magnetic virtual displacements flag.
Applied electric charge density.
Do not show body force load contours.
Show body force load contours.
Show current density as a vector (not a contour).
Shows body force loads as contours on displays for the selected elements.
The effects of the /PBF command are not cumulative (that is, the command does not modify an existing setting from a previously issued /PBF command). If you issue multiple /PBF commands during an analysis, only the setting specified by the most recent /PBF command applies.
Portions of this command are not supported by PowerGraphics [/GRAPHICS,POWER].
This command is valid in any processor.