RPRISM

RPRISM, Z1, Z2, NSIDES, LSIDE, MAJRAD, MINRAD
Creates a regular prism volume centered about the working plane origin.

Compatible Products: – | Pro | Premium | Enterprise | Ent PP | Ent Solver | DYNA

Z1, Z2

Working plane Z coordinates of the prism.

NSIDES

Number of sides in the polygon defining the top and bottom faces of the prism. Must be greater than 2.

LSIDE

Length of each side of the polygon defining the top and bottom faces of the prism.

MAJRAD

Radius of the major (or circumscribed) circle of the polygon defining the top and bottom faces of the prism. Not used if LSIDE is input.

MINRAD

Radius of the minor (or inscribed circle) of the polygon defining the top and bottom faces of the prism. Not used if LSIDE or MAJRAD is input.

Notes

Defines a regular prism volume centered about the working plane origin. The prism must have a spatial volume greater than zero. (i.e., this volume primitive command cannot be used to create a degenerate volume as a means of creating an area.) The top and bottom faces are polygonal areas that are parallel to the working plane but neither face need be coplanar with (i.e., "on") the working plane. The first keypoint defined for each face is at  θ = 0°. See the RPR4 and PRISM commands for other ways to create prisms.

Menu Paths

Main Menu>Preprocessor>Modeling>Create>Volumes>Prism>By Circumscr Rad
Main Menu>Preprocessor>Modeling>Create>Volumes>Prism>By Inscribed Rad
Main Menu>Preprocessor>Modeling>Create>Volumes>Prism>By Side Length

Release 18.2 - © ANSYS, Inc. All rights reserved.