EXUNIT, Ldtype, Load, Untype, Name
Specifies the interface data unit labels to be written to the profile file from
Mechanical APDL to ANSYS CFX transfer.
LdtypeLoad type:
SURF | — | Surface load. |
VOLU | — | Volumetric load. |
LoadSurface loads:
DISP | — | Displacement in a static analysis. Mode shape in a modal analysis. |
TIME | — | Time. The unit for frequency is the inverse of the unit for time. |
MASS | — | Mass. |
TEMP | — | Temperature. |
HFLU | — | Heat flux. |
Volumetric loads:
DISP | — | Displacement. |
FORC | — | Force |
HGEN | — | Heat generation |
UntypeUnit type:
COMM | — | Predefined unit |
USER | — | User-specified unit |
NameCommonly used predefined unit name or user-specified unit name.
SI | — | International System of units (meter-kilogram-second) (default) |
FT | — | English System of units (feet-pound-second) |
In the SI system, surface loads are in units of m for DISP, degrees K for TEMP, and W/m2 for HFLU; volumetric loads are in units of m for DISP, N/m3 for FORC , and W/m3 for HGEN.
In the English system, surface loads are in units of ft for DISP, degrees F for TEMP, and BTU/sec-ft2 for HFLU; volumetric loads are in units of ft for DISP, pdl/ft3 for FORC, and BTU/sec-ft3 for HGEN. A pdl is a poundal, and 32.174 pdl = 1 lbf.
This command only specifies which unit labels are to be written to the file when the EXPROFILE is issued. It does not perform unit conversions.
Distributed ANSYS Restriction This command is not supported in Distributed ANSYS.