LDIV, NL1, RATIO, PDIV, NDIV, KEEP
Divides a single line into two or more lines.
NL1Number of the line to be divided. If negative, assume P1 (see below) is the second keypoint of the line
instead of the first for RATIO. If ALL, divide
all selected lines [LSEL]. If NL1 =
P, graphical picking is enabled and all remaining command fields are ignored
(valid only in the GUI). A component name may also be substituted for NL1.
RATIORatio of line length P1-PDIV to
line length P1-P2.
Must be between 0.0 and 1.0. Input ignored if NDIV >
2.
PDIVNumber to be assigned to keypoint generated at division location
(defaults to lowest available keypoint number [NUMSTR]).
Input ignored if NL1 = ALL or NDIV >
2. If PDIV already exists and lies on line NL1,
divide line at PDIV (RATIO must
also be 0.0). If PDIV already exists and does
not lie on line NL1, PDIV is
projected and moved to the nearest point on line NL1 (if
possible). PDIV cannot be attached to another line,
area, or volume.
NDIVThe number of new lines to be generated from old line (defaults to 2).
KEEPSpecifies whether to keep the input entities:
0 | — | Modify old line to use new keypoints and slopes. |
1 | — | Do not modify old line. New lines will overlay old line and have unique keypoints. |
Divides a single line NL1 (defined from keypoint P1 to keypoint P2)
into two or more lines. Line NL1 becomes the new
line beginning with keypoint P1 and
new lines are generated ending at keypoint P2.
If the line is attached to an area, the area will also be updated. Line
divisions are set to zero (use LESIZE, etc. to modify).