Notes

This command controls options related to the domain decomposition algorithm used by Distributed ANSYS to split the analysis calculations into domains, with each domain being solved on a different process.

The "mesh" algorithm (Decomp = MESH) divides the finite element mesh into domains. In this case, domains are effectively groups of elements, with one domain being solved on each process. This algorithm seeks to create evenly sized domains (that is, domains with equal numbers of elements) as well as to minimize the size of interfaces between the newly created domains. This algorithm can be used for all analysis types.

The "frequency" algorithm (Decomp = FREQ) divides the specified frequency range for a harmonic analysis into domains. In this case, domains are effectively groups of frequency solutions, with one domain being solved on NProcPerSol processes. If there are more processes than frequency points, some processes will remain idle during the harmonic analysis solution. This algorithm seeks to create evenly sized domains. However, if the number of processes does not divide evenly into the number of frequency solutions, the efficiency of the parallel solution will be reduced. This algorithm can only be used for harmonic analyses using the auto (HROPT,AUTO) or full (HROPT,FULL) method.

The "cyclic" algorithm (Decomp = CYCHI) divides the specified list of harmonic indices for a cyclic symmetry modal analysis into domains. In this case, domains are effectively groups of cyclic harmonic indices, with one domain being solved on NProcPerSol processes. If there are more processes than harmonic indices, some processes will remain idle during the cyclic model solution. This algorithm seeks to create evenly sized domains. However, if the number of processes does not divide evenly into the number of harmonic indices, the efficiency of the parallel solution will be reduced.

For the mesh algorithm (MESH), all available processes are used. This is not necessarily the case for the frequency and cyclic algorithms (FREQ and CYCHI).

NProcPerSol is only used when Decomp = FREQ or CYCHI. It defaults to 1, which essentially means that no mesh-based domain decomposition occurs. When NProcPerSol is defined to be greater than 1, a combination of FREQ or CYCHI decomposition and MESH decomposition is employed. As an example, consider a harmonic analysis with 50 requested frequency points (NSUBST,50) that uses distributed processing with 100 CPU cores (-dis -np 100). Specifying DDOPTION,FREQ,2 would lead to 50 parallel sets of calculations, each working on a different frequency point and using 2 cores for mesh-based domain decomposition (that is, 2 groups of elements per frequency).

This command must be issued prior to solving the first load step. Once the first load step is completed, this command cannot be used to change the domain decomposition method. The only exception is for analyses which use the linear perturbation procedure. For this case, the DDOPTION command must be entered prior to the SOLVE,ELFORM command. For more information, see Linear Perturbation Analysis in the Mechanical APDL Structural Analysis Guide

For more information and recommendations on how to choose the domain decomposition method, see Differences in Solution Processing in the Mechanical APDL Parallel Processing Guide.

For the frequency and the cyclic algorithms, solution information for the harmonic frequencies (Decomp = FREQ) or cyclic harmonic indices (Decomp = CYCHI) solved by the slave processes is only written to the output files for those processes (Jobnamen.OUT). See Differences in General Behavior in the Mechanical APDL Parallel Processing Guide for more information.

Menu Paths