ATRAN, KCNTO, NA1, NA2, NINC, KINC, NOELEM, IMOVE
Transfers a pattern of areas to another coordinate system.
KCNTOReference number of coordinate system where the pattern is
to be transferred. Transfer occurs from the active coordinate system. The
coordinate system type and parameters of KCNTO must
be the same as the active system.
NA1, NA2, NINCTransfer area pattern beginning with NA1 to NA2 (defaults
to NA1) in steps of NINC (defaults
to 1). If NA1 = ALL, NA2 and NINC are
ignored and the pattern is all selected areas [ASEL].
If NA1 = P, graphical picking is enabled and all
remaining arguments are ignored (valid only in the GUI). A component name
may also be substituted for NA1 (NA2 and NINC are
ignored).
KINCKeypoint increment between sets. If zero, the lowest available keypoint numbers are assigned [NUMSTR].
NOELEMSpecifies whether elements and nodes are also to be generated:
0 | — | Generate nodes and elements associated with the original areas, if they exist. |
1 | — | Do not generate nodes and elements. |
IMOVESpecifies whether to redefine the existing areas:
0 | — | Generate additional areas. |
1 | — | Move original areas to new position
retaining the same keypoint numbers ( |
Transfers a pattern of areas (and their corresponding lines, keypoints and mesh) from one coordinate system to another (see analogous node TRANSFER command). The MAT, TYPE, REAL, and ESYS attributes are based upon the areas in the pattern and not upon the current settings. Coordinate systems may be translated and rotated relative to each other. Initial pattern may be generated in any coordinate system. However, solid modeling in a toroidal coordinate system is not recommended. Coordinate and slope values are interpreted in the active coordinate system and are transferred directly. Areas are generated as described in the AGEN command.